Loading ...
Loading ...
Loading ...
AGRAS MG-1P SERIES User Manual
© 2018 DJI All Rights Reserved.
25
2. Close the settings menu after linking. The linked aircraft will be listed on the left of the screen
sorted by number.
Switch Control
Users can switch control among different aircraft via the aircraft status box on the left screen in the
app or the Aircraft Control Switch Dial on the remote controller.
Switch in the App
Tap the status box of the corresponding number in the app. The side of the box will turn blue and the
ESC LEDs of the aircraft will blink red quickly, indicating the corresponding aircraft has been selected.
Switch by the Dial
1. Turn the Aircraft Control Switch Dial on the remote controller. There will be an arrow near the
corresponding status box in the app, and the ESC LEDs of the aircraft will blink yellow quickly,
indicating the corresponding aircraft is in pre-selected status.
2. Press the dial once. The side of the box in the app will turn blue and the ESC LEDs of the aircraft
will blink red quickly, indicating the corresponding aircraft has been selected.
Multi-Aircraft Operations
1. Select the desired aircraft by switching control.
2. Tap the status box of the selected aircraft, then tap
on the left of the screen, or tap on top of
the screen to select and use an operation in the “Field” tag. Perform the operation after tapping
Rectify Offset and setting operation parameters. The selected ight routes data will be uploaded
to the aircraft.
3. User an operation to each aircraft. Tap
to show the status boxes of all the aircraft and tap
another status box to switch to the corresponding aircraft.
4. Tap Start after using operations for all the aircraft. Users can slide the sliders for each aircraft
in the prompted window or slide the slider for all aircraft at the bottom position to take off all the
aircraft and start operations at the same time.
5. If there is any emergency during operation, toggle the Pause Switch on the remote controller to
brake all the aircraft. Then all Route operations will be paused and the aircraft will hover in place
and can be controlled manually. To continue the operation, users should use the operation again
in Executing tag in
icon.
Exit from Multi-Aircraft Control Mode
Users can exit from the mode through the following three methods.
Method 1: Link the remote controller to the only one desired aircraft according to the previous
instructions (Single-Machine Pairing should be selected).
Method 2: Delete other aircraft and remain the only one aircraft in the Linked Aircraft list. So the
remote controller can control this aircraft only and perform operations of other operation modes.
Method 3: Power off the other aircraft that don’t need control and power on the only one desired
aircraft. So the remote controller can control this aircraft only and perform operations of other
operation modes. Note: if power on the other aircraft again, the remote controller and the linked
aircraft will enter Multi-Aircraft Control mode automatically. Exit from this mode completely through
method 1 or 2 if needed.
Loading ...
Loading ...
Loading ...