Loading ...
Loading ...
Loading ...
AGRAS MG-1P SERIES User Manual
46
© 2018 DJI All Rights Reserved.
Semi-Automatic Descent: All stick commands except the throttle stick command are
available during descent and landing. Motors will automatically stop after landing.
When operating in no-fly zones, the Aircraft Status Indicators will blink red slowly and
continue for 5 seconds, then switch to indicate the current ying status and continue for
12 seconds, at which point it will switch back to blinking red slowly.
For safety reasons, DO NOT y near airports, highways, railway stations, railway lines, city
centers, or other busy areas. Ensure the aircraft is visible at all times.
Pre-Flight Checklist
1. The remote controller, aircraft battery is fully charged.
2. The pesticides required are adequate.
3. The position of aircraft battery is secured.
4. All parts are mounted securely.
5. All cables are connected correctly and rmly.
6. Propellers are unfolded and mounted onto the motors securely; frame arms are unfolded and
arm sleeves are rmly tightened.
7. Spraying system is without any blockage.
8. Sprinkler hoses are clear from bubbles. Discharge bubbles, as they may lead to operation
problems. Loosen the valve on the side of the spray nozzle and start the pump. Then tighten the
valve and the sprinkler will work properly.
Calibrating the Compass
Because the aircraft’s compass inside the landing gear leg is highly sensitive, it requires calibration
before your rst ight and regularly to ensure optimal ight performance. Lack of calibration can
lead to abnormal compass data, causing poor ight performance or failure.
DO NOT calibrate your compass where there is a chance of strong magnetic interference,
such as magnetite quarries, parking structures, and underground steel reinforcements.
DO NOT carry ferromagnetic objects such as cellular phones with you during calibration.
DO NOT calibrate near massive metal objects.
DO NOT calibrate in an indoor space.
Calibration Procedures
Choose an open space to carry out the following procedures. It is recommended to calibrate the
compass with an empty tank.
1. Go to the app and tap Perform an Operation to enter Operation View. Tap the Aircraft Status
Bar at the top of the screen and select Calibration in the Aircraft Status List, then follow the on-
screen instructions.
2. Hold the aircraft horizontally and rotate it 360 degrees around a vertical axis until the Aircraft
Status Indicators change to solid green and the display goes to the next step in the app.
3. Hold the aircraft vertically, with its nose pointing upward, and rotate it 360 degrees around a
vertical axis.
Loading ...
Loading ...
Loading ...