Dji MG-1P User Manual

Loading ...

AGRAS MG-1P SERIES User Manual

3. Press the Link button on the aircraft. Then release and wait for a few seconds.

4. The Status LED and Link LED will glow solid green if linking is successful.

If the Link LED does not glow solid green, linking failure occurred. Enter linking status again and

retry.

5. Repeat steps 3 and 4 to complete linking between all the aircraft (up to ve) and the remote

controller, if Multi Linking is selected. Then tap End linking.

Multi-Aircraft Control Function

The remote controller features Multi-Aircraft Control function which can be used to coordinate

the operation of up to five aircraft at the same time, enabling pilots to work very efficiently. It is

recommended for large spray areas. Turn the Aircraft Control Switch Dial on the remote controller to

switch between different aircraft for single control of the desired aircraft.

The Multi-Aircraft Control function can only be used in Route operation mode in the current

period. Ensure to complete eld planning and related congurations before entering Multi-

Aircraft Control mode, since operations of other modes cannot be used except Route

operations.

When using the Multi-Aircraft Control function, to avoid interference among operation

groups, do not operate more than three groups within a 50-meter radius. Unless using the

MG-1P RTK with a DJI D-RTK 2 Mobile Station, it is necessary to manually congure each

remote controller’s serial number in the DJI MG app.

Enter Multi-Aircraft Control Mode

1. Link all the aircraft (up to ve) to the same remote controller according to the steps in “Linking

the Remote Controller”.

Linking …

Press the aircraft’s linking button to continue

End linking

Linking the Remote Controller

The remote controller is linked to your aircraft by default. Linking is only required when using a new

remote controller for the rst time. If using Multi-Aircraft Control function, linking all the aircraft to the

same remote controller is required.

1. Power on the remote controller and open the DJI MG app. Power on the aircraft.

2. Tap Perform an Operation to enter Operation View and tap

> . Select Aircraft as the

linking device, tap Single Linking or Multi Linking (if Multi-Aircraft Control is in use), and then

tap Starting Linking. The Status LED blinks blue and the remote controller sounds double beep

repeatedly, indicating that the remote controller is ready for linking.

Loading ...

Dji MG-1P