Loading ...
Loading ...
Loading ...
88
M16 Camera Manual: Installation
ConnectingthePatchCabletoanMX-Overvoltage-Protection-Box,MX-NPA-Boxor
Standard Network Port
First remove the blue bayonet catch and the blue sealing
plug in the right-hand connector on the box to establish the
network connection to an MX-Overvoltage-Protection-Box or
MX-NPA-Box. Then insert the MOBOTIX patch cable into the
box and secure the cable using the bayonet catch.
More information on installing an
MX-NPA-Box
or
an
MX-Overvoltage-Protection-Box
is available at
www.mobotix.com under Product Selector > Accessories >
InterfaceBoxes.
Insert the MOBOTIX patch cable of the M16 into the network port for standard connections
(only permitted in indoor areas).
If additional cables are required inside the housing, they must be connected as described
in Section 2.2.6, «Connecting a USB Cable» and Section 2.2.7, «Connecting a Two-Wire
MxBus* Cable».
2.7.2 Power Supply Using a Switch
1. Connect the factory pre-installed cable of the camera to the camera connector of
the PoE adapter.
2. Connect the LAN/Power connector of the PoE adapter to the Ethernet connector
of the switch/router or the Ethernet port.
3. Plug the RJ45 connector of the power supply unit into the PC/Power connector
of the PoE adapter.
Patch cable
IP addresses in the
diagram are shown
only as an example
For the M16 you should use
the blue MX-NPA-PoE-Set
or the MX-NPA-Box – pre-
vious MOBOTIX network
power accessories, such
as the NPA-Set, Power-
Box and Power-Rack
(MX-NPA-Set, MX-NPR-4
and MX-NPR8/20) are not
suitable for use with the M16
Switch/router
PoE adapter
(MX-NPA-PoE)
Power supply
LAN/www
PC
(10.16.0.11/255.0.0.0)
Camera
(10.16.0.99)
LAN/Power
PC/Power
Camera
RJ45
RJ45
RJ45
Loading ...
Loading ...
Loading ...