Loading ...
Loading ...
Loading ...
74
M16 Camera Manual: Installation
Procedure
1. Install and prepare the network connection: The
pre-installed patch cable attached to the camera
must be connected with the on-site network cable.
The connection can either be established using an
installed in-wall socket with RJ45 connector or, in
the case of a protruding network or patch cable,
using the MX-Patch-Box. In both cases, the connec-
tion is well protected and is neither accessible nor
visible from the outside.
2.
Drill the holes: Use the drilling template for the
camera (available on www.mobotix.com >
Download Center > Documentation > Manuals
or, if used, the extended drilling template inclu-
ded in the MX-Patch-Box package). Drill the holes
for the supplied screw anchors. Screw anchors
do not have to be tted if the surface is made
of wood. To secure the mount, the supplied
stainless steel hex head screws will be screwed
directly into the surface later on. You should
start with a 2-mm drill bit, for example (drilling
depth just slightly less than screw length), in
order to facilitate screwing in wood.
3. Attach wall seal: Place the white rubber sealing
ring with the groove on the edge of the wall mount.
4. Connect the cable: Connect the on-site network
cable to the camera patch cable using an adap
-
ter or insert the patch cable into the RJ45 outlet.
Take note of the installation manual included in the
package when using a MX-Patch-Box. All manuals
can be downloaded and printed (as PDF les) from
the MOBOTIX website (www.mobotix.com) in the
Support > Download Center > Documentation >
Manuals section. Make sure that the cables are not
bent or squashed.
InterfaceBox
M16 Wall Mount
No screw anchors are requi-
red for wooden surfaces
Additional sealing
possible, for example,
with shrink tubing
Loading ...
Loading ...
Loading ...