Loading ...
Loading ...
Loading ...
64
M16 Camera Manual: Installation
Procedure
1. Place the camera face-down on a clean and dry
surface.
2. Remove the two rubber plugs at the back of the
camera housing.
3. Using the supplied 5 mm Allen wrench, loosen the
two bolts at the back of the camera housing. Leave
the bolts and washers in the camera housing.
4. Using the Allen wrench,
cautiously
push from
behind
in an alternating fashion
onto the le and
the right bolt (red arrow in upper gure) and push
the front element out of the front of the housing.
5.
Tilt the front element forward as shown in the gure.
2.2.3 InstallingtheSecurityClips(Optional,NotRequiredforM16Complete
Cameras)
The security clips are protecting the sensor modules or
the blind module in the front element of the M16 against
unwanted rotation (e.g., due to vibration when mounted
on a pole or in an automotive scenario).
Procedure
1.
Open camera housing:
Open the camera housing
as described in Section 2.2.2.
2.
Insert the security clips:
To protect the modules
against unwanted rotation insert the two red secu-
rity clips at the insides of the sensor modules (as
shown in the gure). Make sure that the security
clips click into place as shown in the image detail.
3.
Close camera housing:
Close the camera housing
as described in Section 2.2.8.
Remove rubber plugs at
the back of the housing
using small screwdriver
Not required with M16
Complete Camera
(see Section 1.3.6)
Loading ...
Loading ...
Loading ...