Loading ...
Loading ...
Loading ...
65
First Installation Steps
2.2.4 ExchangingSensorModules
Note that you only need to follow this procedure if the security clips (M11) have been
installed. Since the sensor modules cannot be exchanged from the outside in such a case,
you need to remove the front element, replace the sensor modules and install the front
element again. If no security clips have been installed, you can exchange the sensor modu-
les as described in Section 2.2.1, «Initial Installation of the Sensor Modules (Except M16
Complete Cameras)».
Procedure
1.
Open camera housing:
Open the camera housing
as described in Section 2.2.2.
2.
Remove the security clips
: The sensor or blind
modules may have been protected against unwan-
ted rotation by applying the security clips. Push the
top pf the security clip in the direction of the blue
arrow (see gure in the side note) so that it can pass
the notch and pull the clip upwards.
3.
Remove the sensor module cable from the sensor
or blind module:
The sensor module cables are
secured using a special cable lock with bayonet
catch. To remove the bayonet catch turn it counter-
clockwise until it gently snaps open. Take o the
catch and pull out the cable.
4.
Remove the sensor or blind module
: Set the black
module wrench onto the sensor or blind module,
so that the two notches lock into the two holes of
the module (at the 12 and 6 o’clock positions). Turn
module wrench counter-clockwise by 90 degrees
until it stops.
Push the sensor or blind module out of its socket.
5.
Prepare the new sensor module
: Remove the
plastic lock nut (this is not needed any more).
Remove the bayonet catch by rotating it counter-
clockwise, then remove the blue rubber plug.
M
O
B
O
T
I
X
Loading ...
Loading ...
Loading ...