Loading ...
Loading ...
Loading ...
85
Replacing the MicroSD Card
2.6 Replacing the MicroSD Card
The camera must be taken down to remove, insert, or replace a MicroSD card in use. To
avoid data loss, be sure to deactivate MicroSD card recording in the camera soware and
reboot the MOBOTIX camera before removing the card.
Caution
A MicroSD card may only be removed from the camera aer you have deactivated
recording to the SD card and rebooted the camera. Failing to do so may lead to data
loss! Make sure that the card is not write-protected!
Procedure
1.
Deactivate recording
: Recording to the SD card must be deactivated (Admin Menu >
StorageonExternalFileServer/FlashDevice). If the MicroSD card recording is still
active, deactivate recording, reboot the camera and then disconnect its power supply.
For more information, see Section 3.5, «MicroSD Card Recording».
2.
Open camera housing:
Open the camera housing as described in Section 2.2.2.
3.
Remove connection cable from the inner cover of the housing
: Remove the con-
nector of the sensor cable and the I/O cable (red clips) aer opening the clip catches.
Remove Ethernet cable and any connected MiniUSB cable aer opening the bayonet
catch. Remove MxBus cables. Make sure the front element with the sensor modules
does not fall down.
4.
Remove inner cover
: Remove the four lock screws
on the inner lid (red arrow) using the supplied 2.5-
mm Allen wrench and carefully li o the lid.
Make sure that the interconnections between the
inner lid and the circuit board are not damaged
when removing the inner lid.
The MicroSD card is located at the bottom in the
center of the circuit board.
Make sure not to touch the circuit board when
replacing the MicroSD card!
Loading ...
Loading ...
Loading ...