Loading ...
Loading ...
Loading ...
107
Adjusting Camera, Lens Focus and Installing Filters
3.3.4 Replacing the Dome Against the Sealing Ring (B016 Only)
For special scenarios with hemispheric sensor modules,
e.g., if light entering from the side creates reections within
the dome, you can use the sealing ring instead of the dome
(order no. MX-OPT-Ring-L10-L12).
To exchange the dome against the sealing ring, use the
blue lens wrench supplied with the S15D basic module.
Caution
In order to avoid burns by the hot lens, the sealing ring must not be installed if
the sensor module is within the reach of persons!
Procedure
1. Insert the blue lens wrench into the notches of the
dome. Rotate the wrench tothele until you feel
a stop (max. 300°) and then a little bit further until
the dome slides out of the sensor module. When
doing this, make sure that the dome does not get
stuck in the sensor module housing.
2. Turn the wrench over, insert the two notches into
the slots of the lens’ metal ring and unscrew the lens
until you can remove it from the sensor module.
3. Insert the lens into the sealing ring as shown.
4. Fully insert the lens into the sealing by pressing
rmly on two sides of the lens, until the metal rim
of the lens is on the same level as the sealing.
M.7
Loading ...
Loading ...
Loading ...