Loading ...
Loading ...
Loading ...
105
Adjusting Camera, Lens Focus and Installing Filters
3.3.2 AdjustingLensFocus(B119/B237Only)
Once the camera has been installed, the B119 and B237 sensor modules should be checked
for proper image sharpness and manually adjusted, if required. To do so, use the blue lens
wrench and the black module wrench (both are supplied with the M16 basic module).
The focusing aid provides a visual aid when correcting the image sharpness (see The Live
Screen of the MOBOTIX Camera in the camera’s online help).
Procedure
1. Position the blue lens wrench on the notches of
the sensor module. Rotate the wrench tothele
until you feel a stop (max. 300°) and then a little bit
further until the protective glass lens slides out of
the sensor module.
2. Adjust the image sharpness according to the
camera’s live image on the computer monitor. To
do so, position the black module wrench (with the
ring-pattern side) on the lens and carefully rotate
to the right or le.
Do not turn the lens too far or
with force to avoid damaging the image sensor.
3. If required, clean the inside of the protective glass
lens using a clean, lint-free cotton cloth.
4. Place the protective glass lens on the notches of
the blue lens wrench.
5.
Position the protective glass lens with its clips over
the two receptacles on the sensor module (red arrow
on the image in the margin) and rmly press onto
the sensor module. Rotate the glass to the right
using the blue lens wrench until you feel a stop.
6. If required, clean the outside of the protective glass lens using a clean, lint-free cot
-
ton cloth.
M.6
M.7
Loading ...
Loading ...
Loading ...