Loading ...
Loading ...
Loading ...
8.3.7 General Sengs
Set Authencaon Parameters
Set Authencaon Parameters.
Steps
1.
Tap Conguraon → General Sengs → Authencaon Sengs .
2.
Tap Save.
Device Type
Main Card Reader
You can congure the device card reader's parameters. If you select main card reader, you
need to congure the following parameters: Card Reader Type, Card Reader Descripon,
Enable Card Reader, Authencaon, Recognion Interval (s), Max.Authencaon Failed
Aempts Alarm/Alarm of Max. Failed Aempts.
Card Reader Type
Get card reader type.
Card Reader Descripon
Get card reader descripon. It is read-only.
Enable Card Reader
Enable the card reader's funcon.
Authencaon
Select an authencaon mode according to your actual needs from the drop-down list.
Recognion Interval
If the interval between card presenng of the same card is less than the congured value, the
card presenng is invalid. The interval me range is from 0 to 255 seconds (When set to 0, it
means that recognion interval is not enabled, and the same authencaon can be used for
unlimited mes).
Mulple People Authecaon
Aer mulple faces authencaon is enabled, mulple faces authencaon is supported.
Max. Authencaon Failed Aempts Alarm/Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Set Privacy Parameters
Set the event storage type, picture upload and storage parameters, and the picture clearing
parameters.
DS-K1A340 Series Face Recognion Terminal User Manual
67
Loading ...
Loading ...
Loading ...