Loading ...
Loading ...
Loading ...
70 UTD1000L User Manual
10. Press F3 to recall, “Load Success” will show to indicate the waveform has been
successfully displayed on the screen too;
11. Press F4 to turn off the current reference waveform.
6.9 Making Cursor Measurements
To make cursor measurements, do the following:
1. Press SHIFT and shift icon shows on upper right part of display.
2. Press CURSOR to access cursor menu;
3. Press F2 of UTD1000DL to choose the channel for cursor measurement (No selection
for UTD1000CL, it defaults at CH1)
4. Press F1 to set up measuring type.
There are two options available for measuring Type in cursor menu: Voltage and Time.
When measuring voltage, use SELECT and arrow buttons to adjust the locations of two cursors
in order to measure ΔV parameter, do the same with Δt measurement.
Voltage/Time Measurement Tips: Cursor 1 and Cursor 2 shows simultaneously on the screen,
use arrow buttons to remove the cursors and press SELECT to choose and adjust the desired
one. Displayed readout is the voltage or time between two cursors.
When the cursor function turns on, measuring values can be automatically shown on upper
left corner of the display.
Figure 6-28 Cursor Menu for Time Measurement
Table 6-15
Menu
Settings
Description
Type Time Use the cursor to measure the time
Mode Independent
Tracking
Move each cursor independently
Move two cursors simultaneously and keep Δt
unchanged
Vertical Unit Sec
Hz
measurement parameter is time
measurement parameter is frequency
Func Switch Channel Use arrow buttons to set the target to channel
Loading ...
Loading ...
Loading ...