Loading ...
Loading ...
Loading ...
281, 282, 284
Users Manual
wv01 wv02
00000 strt 00400
00512 stop 01000
exit insert
Wave insert places waveforms between programmable start and stop points. Both
standard and arbitrary waveforms can be inserted in the new waveform, with the
exception of pulse, pulse-train and sequence.
You can insert a section of an arbitrary waveform, defined by the left-hand strt (start)
and stop addresses, for example points 00000 to 00512 of wv01 on the
screen above. These start and stop addresses default to the start and stop addresses of the
entire waveform being inserted, but you can adjust the addresses to define any section of
the waveform.
Change the addresses by pressing the appropriate soft-key and making entries from the
keyboard or by rotary control.
The destination of the selected section of the source waveform in the new waveform is
defined by the right-hand strt and stop addresses. Again, change the addresses by
pressing the appropriate soft-key and making entries from the keyboard or by rotary
control.
The insertion is completed by pressing the insert soft-key.
If there is a size difference between the two sections of waveform then the software will
expand or compress the source address space to fit the new waveform. As before,
compressing the waveform may cause you to lose some significant data.
To insert sections of the current waveform within itself see the next section, Block Copy.
Block Copy
Pressing block copy… calls the BLOCK COPY screen:
BLOCK COPY: execute
start: 00400 exit
stop: 01000 undo
dest: 00000 save
Block copy allows a section of the current waveform to be inserted within itself. The
block to be inserted is defined by the start and stop addresses. Change the
addresses by pressing the appropriate soft-key and making entries from the keyboard or
by rotary control.
The destination address for the start of the section is set by pressing the dest soft-key
and entering the address. The effect of making the block copy can then by previewed by
pressing the execute soft-key.
Note that if there are not enough waveform points between the destination address and
end of waveform to accommodate the copied section, the waveform being copied will
simply be truncated. The copy can be removed by pressing the undo soft-key or by
entering a new destination address.
9-10
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...