Loading ...
Loading ...
Loading ...
281, 282, 284
Users Manual
B-2
83 Numeric value too large - switching to sample period
Error Messages
101 Frequency out of range for the selected waveform
102 Sample clock frequency required exceeds 40 MHz
103 Sample clock frequency required is less than 0.1 Hz
104 Pulse/pulse-train period out of range for current set-up
105 Pulse width cannot be greater than the period
106 Absolute value of pulse delay must be < period
107 Pulse width cannot be less than 25 ns
108 Maximum output level exceeded
109 Minimum output level exceeded
110 Minimum dc offset value exceeded
111 Maximum dc offset value exceeded
112 The value entered is out of range
115 There are no arb waveforms defined Use WAVEFORM CREATE
116 Cannot delete arb while it is selected for any output chan
117 Arb name exists, names must be unique
118 Arb waveform length exceeds available memory
119 Arb waveform length cannot be less than four points
121 Start address error: must be in the range 0 <= n <= stop addr
122 Stop address error: must be in the range strt <= n <= wfm len
125 No GPIB available
127 System ram error check battery
128 Point value error: must be in the range -2048 <= n <= +2047
129 Wave offset error: must be in the range -4096 <= n <= +4095
131 Wave amplitude error must be in the range 0 <= n <= 100
132 Block dest error: must be in the range 0 <= n <= wfm len-4
133 Sequence count value exceeds the maximum of 32,768
134 Sequence count value cannot be less than 1
135 Trigger generator maximum period is 200 s
136 Trigger generator minimum period is 10 us
138 Burst count value exceeds the maximum of 1,048,575
139 Burst count value cannot be less than 1
140 Trig/Gate freq too high. Max=1 MHz. Continuous mode set
141 Selected function is illegal in tone m
ode TONE MODE CANCELLED!
144 Selected combination of function and m
ode is illegal
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...