Loading ...
Loading ...
Loading ...
Remote Operation
Remote Commands16
16-17
ARBAMPL <cpd>,<nrf1>,
<nrf2>,<nrf3>
Adjust the amplitude of arbitrary waveform
<cpd> in the address range <nrf1> to
<nrf2> by the factor <nfr3>.
ARBOFFSET <cpd>,<nrf1>,
<nrf2>,<nrf3>
Move the data in arbitrary waveform
<cpd>
in the address range <nrf1> to
<nrf2> by the offset <nrf3>.
ARBINVERT <cpd>,<nrf1>,
<nrf2>
Invert arbitrary waveform <cpd> in the
address range <nrf1>
to <nrf2>.
ARBLEN? <cpd> Returns the length, in points, of the
arbitrary
waveform <cpd>. If the
waveform does not exist the return value
will be 0.
POSNMKRCLR <cpd> Clear all position markers from arbitrary
wavefor
m <cpd>.
POSNMKRSET <cpd>,<nrf> Set the position marker at address <nr
f>
in arbitrary waveform <cpd> to 1 (high).
POSNMKRRES <cpd>,<nrf> Clear the position marker at address
<nrf>
in arbitrary waveform <cpd> to
0 (low).
POSNMKRPAT
<cpd1>,<nrf1>,<nrf2>,
<cpd2>
Put the pattern <cpd2>
into the arbitrary
waveform <cpd1> from start address
<nrf1> to stop address <nrf2>.
The pattern may contain up to 16 entries of
'1
' or '0'; no other characters are allowed.
Waveform Sequence Control
SEQWFM <nrf>,<cpd> Set the 'waveform' parameter for sequence
seg
ment <nrf> to <cpd>.
<cpd> m
ust be the name of an existing
arbitrary waveform.
SEQSTEP <nrf>,<cpd> Set the 'step on' parameter for sequence
seg
ment <nrf> to <COUNT>,
<TRGEDGE> or <TRGLEV>.
SEQCNT <nrf1>,<nrf2> Set count for sequence segment <nrf
1>
to <nrf2>.
SEQSEG <nrf>,<cpd> Set the status of sequence segment <nrf>
to <ON>
or <OFF>.
Mode Commands
MODE <cpd> Set the mode to <CONT>
, <GATE>,
<TRIG>, <SWEEP> or <TONE>.
BSTCNT <nrf> Set the burst count to <n
rf>.
PHASE <nrf> Set the generator phase to <nrf>
degrees. This parameter is used for phase
locking and trigger/gate mode start/stop
phase.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...