Loading ...
Loading ...
Loading ...
Plug-Ins 297
Installing on S6L System
To install components onto your S6L system:
1 Make sure you have installed VENUE software version 5.7 or higher, and that your system is powered on.
2 Install Waves Central by doing the following:
• Connect the USB drive on which you built your Waves installer to an available USB port on the S6L control surface.
• Enable Config mode, navigate to Options > System, then select Update. When prompted to confirm that you want to install
Waves Central, click INSTALL.
• Follow the on-screen instructions to install Waves Central.
•Click Finish.
• When prompted to restart, click OK.
3 Install Waves plug-ins by doing the following:
• After the system restarts, enable Config mode.
• Go to Options > Devices, select the WSG-HD card in the Expansion Cards list, click to display the Settings tab in the In-
formation section and then click Launch Waves Central.
•Select Install.
• Install From: your USB key.
• Choose Products to Install: SoundGrid Rack for VENUE, as well as any plug-ins you want to install.
•Click Install. Wait while the installation completes (it takes several minutes).
• When the message Products from Package were Successfully Installed appears, click OK.
• Close Waves Central.
• Enable Config mode.
• Go to
Options > Plug-Ins, select WaveShell1SoundGridRack-AAX and click Install.
• When installation is finished, restart your S6L system.
4 Set up Inventory by doing the following:
• Enable Config mode.
• Go to Options > Devices, select the WSG-HD card in the Expansion Cards list, click to display the Settings tab in the In-
formation section and then click Show Inventory.
5 Set the Network Port to the Intel port number ending in “LM” (such as Intel(R)82579LM Gigabit Network Connection).
Options > Devices showing Settings for a WAVES-SG card selected in Expansion Card slot 6
Selecting a network port
Loading ...
Loading ...
Loading ...