Loading ...
Loading ...
Loading ...
Converting to LP Gas (orCo.verti.gBacktoNaturalGasfromLP)
This range leaves the factory set for use with natural ga&
If you convert to LP gas, keep these instructions and ori-
fices in case you want to convert back to natura{ gas
Prepare the Range for Conversion
CAUTION--Before converting the range:
(1) Turn off gas supply at the wall and
(2) Turn off the electrical power to the range.
If range has not yet been connected to gas supply, or
if flexible connection was made, range may be pulled
out from the wall to make conversion easier.
Tools Required:
= T-10 Torxdriver (for sealed burners)
o 1/2" and 3/4" open-end wrench
• Flat blade screwdriver (small)
=Nut drivers or wrenches: 7ram, 5/16" or a small
adjustable (depending on the size of the spuds)
$ ep t
Convert The Pressure Regulator
WARNING: Do not remove the pressure regu-lator from the range.
1. For models equipped with sealed burners, remove
the storage drawer, broiler drawer or kick panel and
locate the pressure regulator at rear of the range
Remove Screws __
Access Cover/L_ __
On some models, you may have to remove an access
cover also,
For models equipped with dual burners, remove the
cooktop and locate the pressure regulator at right rear
of range.
2. Follow the directions in A or B, that match your reg-
ulator type.,
A Dual Burner Models
(models with lift-up cooktops)
If it is regulator A:
1. Use a coin to remove the cap from the pressure
regulator,
2. Turn the cap over and hook it into the slots,,
The type of gas to be used should now be visible
on the top of the cap.
B Sealed Burner Models
(models without lift-up cooktops)
If it is regulator B:
1. Unscrew the plastic*protected hex-nut cap from the
regulator.,
2. Carefully pry the protective plastic cap off
the threaded metal cap,, Gently pull the plastic
washer off the threads on the other side of the
metal cap.
3. Push the plastic cap onto the end of the metal cap
displaying the type of gas you are converting to,
Press the attached plastic washer onto the threads
on the other side of the metal cap.
4. Screw the hex-nut cap back into the regulator. Do
not overtighten
A DUAL BURNERS
NAT
Cap
into Range _
TO OPEN
SEALED BURNERS
Gas
Lever shown closed Flow into
PUSH DOWN
TO OPEN
Do not remove
this protective cap
except for conversion
Cap Assembly
(continued next page)
4l
Loading ...
Loading ...
Loading ...