Loading ...
Loading ...
Loading ...
DXS-3400 Series Lite Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide
134
Parameter Description
was selected as the action.
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
After clicking the Add Rule button next to an IP type profile, the following page will appear.
Figure 5-45 VLAN Mapping Profile (IP, Add Rule) Window
The fields that can be configured are described below:
Parameter Description
Rule ID
Enter the VLAN mapping rule’s ID here. If not specified, the rule ID begins from
10 and is incremented by 10 for every new rule. The range is from 1 to 10000
Src-IP Address (IP/Mask)
Enter the source IPv4 address and subnet mask here.
Dst-IP Address (IP/Mask)
Enter the destination IPv4 address and subnet mask here.
DSCP
Enter the DSCP value here. The range is from 0 to 63.
Source Port
Enter the source TCP/UDP port’s number here. The range is from 1 to 65535.
Destination Port
Enter the destination TCP/UDP port’s number here. The range is from 1 to 65535.
IP Protocol
Enter the Layer 3 IP protocol value here. The range is from 0 to 255.
Action
Select the action that will be taken here. Options to choose from are Dot1q-
Tunnel and Translate.
• Dot1q-Tunnel - Specifies that the outer-VID will be added for matched
packets.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
New Outer VID
Enter the new outer VLAN’s ID here. The range is from 1 to 4094.
802.1P Priority
Select the 802.1p priority value here. The range is from 0 to 7. A lower value has
a higher priority.
New Inner VID
After selecting Dot1q-Tunnel as the action, enter the new inner VLAN’s ID here.
The range is from 1 to 4094. This option is only available when Dot1q-Tunnel
was selected as the action.
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
Loading ...
Loading ...
Loading ...