Loading ...
Loading ...
Loading ...
WHEELS AND TIRES
}}
* Option/accessory.
329
WARNING
If heavy vibrations, unsteady steering behavior,
or noises should occur while driving, reduce
speed and park the vehicle in a safe place.
Recheck the tire for bumps, cracks, or other
visible damage, and recheck its inflation pres-
sure. If the pressure is below 19 psi (1.3 bar),
do not continue driving. Have the vehicle
towed to a trained and qualified Volvo service
technician.
Tire sealing system – checking
inflation pressure
The tire sealing system can also be used to
check the tires' inflation pressure.
Stage 2: Checking inflation pressure
1. Reconnect the tire sealing system's hose to
the tire's inflation valve as described in stage
1, see Tire sealing system* – sealing a hole
(p. 327).
2. Refer to the inflation pressure table in this
chapter for the correct inflation pressure. If
the tire needs to be inflated, start the tire
sealing system’s compressor. If necessary,
release air from the tire by turning the air
release knob counterclockwise.
CAUTION
The compressor should not be used for more
than 10 minutes at a time to avoid overheat-
ing.
WARNING
If you interrupt your trip for more than 1 hour,
check the inflation pressure in the damaged
tire again before continuing.
Tire sealing system* – inflating tires
The tire sealing system can be used to inflate
the tires.
To do so:
1. Park the car in a safe place.
2. The compressor should be switched off.
Ensure that the on/off switch is in position
0 (the 0 side of the switch should be
pressed down).
3. Take out the electrical wire and hose.
4. Remove the valve cap from the tire’s inflation
valve and screw the hose connector onto the
valve as tightly as possible by hand.
5. Connect the electrical wire to the nearest
12-volt socket in the vehicle.
6. Start the vehicle’s engine.
Loading ...
Loading ...
Loading ...