Loading ...
Loading ...
Loading ...
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1.
This device may not cause harmful interference.
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
Full Brake Control System With Mitigation
The Full Brake Control system with mitigation
provides the driver with audible warnings, visual
warnings (within the instrument cluster display),
and may apply a brake jerk to warn the driver
when it detects a potential frontal collision.
The warnings and limited braking are intended to
provide the driver with enough time to react,
avoid or mitigate the potential collision.
NOTE:
• Full Brake Control System monitors the infor-
mation from the forward looking sensors as
well as the Electronic Brake Controller (EBC),
to calculate the probability of a forward colli-
sion. When the system determines that a for-
ward collision is probable, the driver will be
provided with audible and visual warnings and
may provide a brake jerk warning.
• If the driver does not take action based upon
these progressive warnings, then the system will
provide a limited level of active braking to help
slow the vehicle and mitigate the potential
forward collision. If the driver reacts to the
warnings by braking and the system determines
that the driver intends to avoid the collision by
braking but has not applied sufficient brake
force, the system will compensate and provide
additional brake force as required.
After the end of the intervention of automatic
braking, the transmission may remain in last gear
stored: therefore the car could lurch forward,
once the brakes release a few seconds later. If the
Full Brake Control System event stops the vehicle
completely, the system will hold the vehicle at
standstill for two seconds and then release the
brakes.
If a Full Brake Control System event begins at a
speed below 26 mph (42 km/h), the system may
provide the maximum braking possible to mitigate
the potential forward collision. If the Full Brake
Control System event stops the vehicle com-
pletely, the system will hold the vehicle at standstill
for two seconds and then release the brakes.
When the system determines a collision with the
vehicle in front of you is no longer probable, the
warning message will be deactivated.
Full Brake Control System Message
61
Loading ...
Loading ...
Loading ...