Loading ...
Loading ...
Loading ...
FRONT AND REAR PARK
ASSIST — IF EQUIPPED
The Park Assist system provides visual and audible
indications of the distance between the rear
and/or front fascia and a detected obstacle when
backing up or moving forward, e.g. during a
parking maneuver.
Refer to “Park Assist System Usage Precautions” for
limitations of this system and recommendations.
Park Assist will retain the last system state (enabled
or disabled) from the last ignition cycle when the
ignition is changed to the ON/RUN position.
Park Assist is active when the gear selector is
shifted to REVERSE or to a for ward gear and an
obstacle is detected, as long as the system is ON.
When the gear selector shifted to NEUTRAL (or
PARK in case of automatic gearbox), t he system
becomes inactive. When the vehicle is moving
forward, the system will remain active until the
vehicle speed remains below approximately
11 mph (18 km/h). Reducing the speed approxi-
mately below 9 mph (15 km/h), the system will
come back active. When the vehicle is moving in
REVERSE, the system will remain active as long as
the speed remains below the maximum operating
speed of 7 mph (11 km/h). When the maximum
speed limit is exceeded, the sys tem is disabled and
the Park Assist switch LED with illuminate. The sys-
tem will become active again if the vehicle speed
reduces below approximately 6 mph (9 km/h).
Park Assist Sensors
The four Park Assist sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors’ field of view. The
sensors can detect obstacles from approximately
12 inches (30 cm) up to 59 inches (150 cm) from
the rear fascia/bumper in the horizontal direction,
depending on the location, type and orientation
of the obstacle.
The four Park Assist sensors, located in the front
fascia/bumper, monitor the area in front of the
vehicle that is within the sensors’ field of view.
The sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 39 inches
(100 cm) from the front fascia/bumper in the
horizontal direction, depending on the location,
type and orientation of the obstacle.
Enabling And Disabling Park Assist
Park Assist can be enabled and disabled with the
Park Assist switch, located on the switch panel
below the Uconnect display.
When the Park Assist switch is pushed to disable
the system, the instrument cluster display will
show the “Park Assist Disabled” message for
approximately five seconds. Refer to “Instrument
Cluster Display” in “Getting To Know Your Instru-
ment Panel” in your Owner’s Manual for further
details.
The Park Assist switch LED turns on when the
system is disabled by pushing the switch, as well as
in case of failure or temporary disabling condi-
tions.The Park Assist switch LED will be off when
the system is enabled. If the Park Assist switch is
pushed, and requires service, the Park Assist
switch LED will blink momentarily, and then the
LED will be on.
STARTING AND OPERATING
114
Loading ...
Loading ...
Loading ...