Loading ...
Loading ...
Loading ...
WARNING!
Leaving the Adaptive Cruise Control (ACC)
system on when not in use is dangerous. Yo u
could accidentally set the system or cause it to
go faster than you want.You could lose control
and have a collision. Always leave the system
off when you are not using it.
Activating Adaptive Cruise Control (ACC)
The minimum set speed for the ACC system is
20 mph (32 km/h) and the maximum speed is
100 mph (160 km/h).
When the system is turned on and in the ready
state, the instrument cluster display will read
“ACC Ready.”
When the system is off, the instrument cluster
display will read “Adaptive Cruise Control (ACC)
Off.”
NOTE:
You cannot engage ACC under the following
conditions:
• When in Four-Wheel Drive Low.
• When you apply the brakes.
• When t he parking brake is applied.
• When the automatic transmission is in PARK,
REVERSE or NEUTRAL.
• When the vehicle speed is outside of the speed
range.
• When t he brakes are overheated.
• When t he ESC, ABS, or other stability control
systems are operating or have just operated.
• During automatic braking by the Full Brake
Control system (if equipped).
• When Speed Control is activated.
To Set A Desired ACC Speed
When the vehicle reaches the speed desired,
push the SET (+) button or the SET (-) button
and release. The instrument cluster display will
show the set speed.
NOTE:
ACC cannot be set if there is a stationary vehicle
in front of your vehicle in close proximity.
Remove your foot from the accelerator pedal.
If you do not, the vehicle may continue to
accelerate beyond the set speed. If this occurs:
•
The message “Adaptive Cruise Control Override”
will display in the instrument cluster display.
• The system will not be controlling the distance
between your vehicle and the vehicle ahead.
The vehicle speed will only be determined by
the position of the accelerator pedal.
To Resume
If there is a set speed in the memory, push the
RES button and then remove your foot from the
accelerator pedal. The instrument cluster display
will show the last set speed.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming a
set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to follow
these warnings can result in a collision and
death or serious personal injury.
STARTING AND OPERATING
108
Loading ...
Loading ...
Loading ...