Loading ...
Loading ...
Loading ...
• The ACC system decelerates the vehicle to a
full stop when following a target vehicle. If an
ACC host vehicle follows a t arget vehicle to a
standstill, after two seconds the driver will
either have to push the RES (resume) button, or
apply the accelerator pedal to reengage the
ACC to the existing set speed.
• The ACC system maintains set speed when
driving up hill and down hill. However, a slight
speed change on moderate hills is normal. In
addition, downshifting may occur while climbing
uphill or descending downhill. This is normal
operation and necessary to maintain set speed.
When driving up hill and down hill, the ACC
system will cancel if the braking temperature
exceeds normal range (overheated).
• If “Sport” mode is chosen on the Dynamic
Selector, the ACC system will switch to sport
mode.The system will become more reactive in
case of acceleration.
Setting The Following Distance In ACC
T
he specified following distance for ACC can be set
by varying the distance setting between four bars
(longest), three bars (long), two bars (medium) and
one bar (short). Using this distance setting and the
vehicle speed, ACC calculates and sets the distance
to the vehicle ahead.This distance setting will show
in the instrument cluster display.
To increase the distance setting, push the Dis-
tance Setting — Increase button and release.
Each time the button is pushed, the distance
setting increases by one bar (longer). Once the
longest setting is reached, if the button is pushed
again it will be set to the shortest setting available.
To decrease the distance setting, push the Dis-
tance Setting — Decrease button and release.
Each time the button is pushed, the distance
setting decreases by one bar (shorter).
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1.
This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equip-
ment.
Changes or modifications to any of these systems
by other than an authorized ser vice facility could
void authorization to use this equipment.
STARTING AND OPERATING
110
Loading ...
Loading ...
Loading ...