Loading ...
Loading ...
Loading ...
CAUTION!
Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the “park” position. If the wind-
shield wiper switch is turned off, and the
blades cannot return to the “park” position,
damage to the wiper motor may occur.
Windshield Wiper Operation
Rotate the windshield wiper knob to one of the
two detent positions for intermittent settings, the
third detent for low wiper operation and the
fourth for high wiper operation.
Windshield Washer Operation
To use the washer, pull the lever toward you and
hold while spray is desired. If the lever is pulled
while in the intermittent setting, the wipers will
turn on and operate for several wipe cycles after
the lever is released, and then resume the
intermittent interval previously selected.
If the lever is pulled while the wipers are in the
off position, the wipers will operate for several
wipe cycles, then turn off.
WARNING!
Sudden loss of visibility through the windshield
could lead to a collision.You might not see other
vehicles or other obstacles.To avoid sudden icing
of the windshield during freezing weather, warm
the windshield with the defroster before and
during windshield washer use.
Mist
Use this feature when weather conditions make
occasional usage of the wipers necessary. Push
the lever upward to the MIST position and
release for a single wiping cycle.
NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed
on the windshield. The wash function must be
used in order to spray the windshield with washer
fluid.
Rain Sensor — If Equipped
This feature senses moisture on the windshield
and automatically activates the wipers for the
driver. The feature is especially useful for road
splash or overspray from the windshield washers
of the vehicle ahead. Rotate the end of the
multifunction lever to one of two settings to
activate this feature.
NOTE:
If the end of the multifunction lever rotates from
the off (O) position to the first intermittent
setting or from the first intermittent setting to
the second intermittent setting, the wipers will
perform a round up to clean the windshield.
The sensitivity of the system can be adjusted with
the multifunction lever. Wiper delay position one
is the least sensitive, and wiper delay position two
is the most sensitive. Setting one should be used
for normal rain conditions, and can be used if the
driver desires less wiper sensitivity. Setting two
can be used if the driver desires more sensitivity.
Place the wiper switch in the off (O) position
when not using the system.
GETTING TO KNOW YOUR VEHICLE
30
Loading ...
Loading ...
Loading ...