Loading ...
Loading ...
Loading ...
• The park lamps will turn on and remain on
during Remote Start mode.
•
For security, power window operation is disabled
when the vehicle is in the Remote Start mode.
• The engine can be started two consecutive
times (two 15-minute cycles) with the key fob.
However, the ignition must be placed in the
ON/RUN position before you can repeat the
start sequence for a third cycle.
General Information
T
he following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1.
This device may not cause harmful interference,
and
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The vehicle security alarm monitors the vehicle
doors, hood, lif tgate, and the Keyless Enter-N-Go
— Ignition for unauthorized operation.While the
vehicle security alarm is armed, interior switches
for door locks and lif tgate release are disabled.
If something triggers the alarm, the vehicle secu-
rity alarm will provide the following audible and
visible signals:
• The horn will pulse.
• The turn signals will flash.
• The vehicle security light in the instrument
cluster will flash.
To Arm The System
Follow these steps to arm the vehicle security
alarm:
1. Make sure the vehicle’s ignition is placed in the
“OFF” mode.
2. Perform one of the following methods to lock
the vehicle:
• Push the lock button on the interior power
door lock switch with the driver and/or
passenger door open.
• Push the lock button on the exterior
Passive Entry Door Handle with a valid key
fob available in the same exterior zone
(refer to "Doors" in "Getting To Know Your
Vehicle" in your Owner’s Manual for fur-
ther information).
• Push the lock button on the key fob.
3. If any doors are open, close them.
To Disarm The System
The vehicle security alarm can be disarmed using
any of the following methods:
• Push t he unlock button on the key fob.
• Grasp the passive entry door handle to unlock
the door, refer to "Doors" in "Getting To Know
Your Vehicle" in your Owner’s Manual for fur-
ther information.
• Cycle the ignition out of the off mode to disarm
the system.
15
Loading ...
Loading ...
Loading ...