Loading ...
Loading ...
Loading ...
WARNING!
• Take care to avoid the radiator cooling fan
whenever the hood is raised. It can start
anytime the ignition switch is ON. You can
be injured by moving fan blades.
• Remove any metal jewelry such as rings,
watch bands and bracelets that could
make an inadvertent electrical contact.
You could be seriously injured.
• Batteries contain sulfuric acid that can
burn your skin or eyes and generate hydro-
gen gas which is flammable and explosive.
Keep open flames or sparks away from the
battery.
NOTE:
Be sure that the disconnected cable ends do not
touch each other, or either vehicle, until prop-
erly connected for jump starting.
1. Apply the parking brake, shift the automatic
transmission into P ARK and turn the ignition
OFF.
2. Turn off the heater , radio, and all unneces-
sary electrical accessories.
3. Remove the protective cover over the remote
positive (+) battery post. Pull upward on the
cover to remove it.
4. If using another vehicle to jump start the
battery, park the vehicle within the jumper
cables reach, apply the parking brake and
make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as
this could establish a ground connection and
personal injury could result.
Jump Starting Procedure
WARNING!
Failure to follow this jump starting procedure
could result in personal injury or property
damage due to battery explosion.
CAUTION!
Failure to follow these procedures could re-
sult in damage to the charging system of the
booster vehicle or the discharged vehicle.
NOTE:
Make sure at all times that unused ends of
jumper cables are not contacting each other or
either vehicle while making connections.
Connecting The Jumper Cables
1. Connect the positive (+) end of the jumper
cable to the remote positive (+) post of the
discharged vehicle.
2. Connect the opposite end of the positive (+)
jumper cable to the positive (+) post of the
booster battery.
3.
Connect the negative end
(-) of the jumper
cable to the negative (-) post of the booster
battery.
4. Connect the opposite end of the negative (-)
jumper cable to the remote negative (-) post
of the vehicle with the discharged battery.
WARNING!
Do not connect the jumper cable to the negative
(-) post of the discharged battery. The resulting
electrical spark could cause the battery to ex-
plode and could result in personal injury. Only
use the specific ground point, do not use any
other exposed metal parts.
189
Loading ...
Loading ...
Loading ...