Loading ...
Loading ...
Loading ...
3-52
Instruments and controls
blades.
NOTE
" The front wiper motor is protected against over-
loads by a circuit breaker. If the motor operates
continuously under an unusually heavy load, the
circuit breaker may trip to stop the motor tempo-
rarily. If this happens, park your vehicle in a safe
place, turn off the wiper switch, and wait for ap-
proximately 10 minutes. The circuit breaker will re-
set itself, and the wipers will again operate nor-
mally.
" Clean your wiper blades and window glass peri-
odically with a washer solution to prevent streak-
ing, and to remove accumulations of road salt or
road film. Keep the washer button depressed at
least for 1 second so that washer solution will be
sprinkled all over the windshield or rear window.
" Grease, wax, insects or other material on the
windshield or the wiper blades results in jerky wip-
er operation and streaking on the glass. If you can-
not remove those streaks after operating the
washer or if the wiper operation is jerky, clean the
outer surface of the windshield or rear window
and the wiper blades using a sponge or soft cloth
with a neutral detergent or mild-abrasive cleaner.
After cleaning, rinse the window glass and wiper
blades with clean water. The glass is clean if no
beads form on the glass when you rinse with wa-
ter.
" If you cannot eliminate the streaking even after
following this procedure, replace the wiper blades
with new ones. Refer to the “Replacement of wiper
blades” section (chapter 11) for replacement in-
structions.
! Windshield wiper and washer switches
The wiper operates only when the ignition switch is in
the “ON” or “ACC” position.
Loading ...
Loading ...
Loading ...