Loading ...
Loading ...
Loading ...
1-91
Seat, seatbelt and SRS airbags
– CONTINUED –
! SRS airbag system servicing
" When discarding an airbag module or scrap-
ping the entire vehicle damaged by a collision,
consult your SUBARU dealer.
" The SRS airbag has no user-serviceable
parts. Do not use electrical test equipment on
any circuit related to the SRS airbag system.
For required servicing of the SRS airbag, see
your nearest SUBARU dealer. Tampering with
or disconnecting the system’s wiring could re-
sult in accidental inflation of the SRS airbag or
could make the system inoperative, which may
result in serious injury. The wiring harnesses of
the SRS airbag system are covered with yellow
insulation and system connectors are yellow
for easy identification.
If you need service or repair in areas listed be-
low, have an authorized SUBARU dealer per-
form the work. The SRS airbag control module,
impact sensors and airbag modules are stored
in these areas.
" Under the center console
" Inside each front fender
" Steering wheel and column and nearby areas
" Top of the dashboard on front passenger’s
side and nearby areas
" Each front seat and nearby area
" Inside each center pillar
" In each roof side (from the front pillar to a
point over the rear seat)
" Between the rear seat cushion and rear wheel
house on each side
In the event that the SRS airbag is deployed, re-
placement of the system should be performed
only by an authorized SUBARU dealer. When the
components of the SRS airbag system are re-
placed, use only genuine SUBARU parts.
NOTE
In the following cases, contact your SUBARU deal-
er as soon as possible.
" The front part of the vehicle was involved in an
accident in which the only the driver’s SRS frontal
airbag or both driver’s and front passenger’s SRS
frontal airbags did not deploy.
" The pad of the steering wheel, the cover over the
front passenger’s SRS frontal airbag, or either
Loading ...
Loading ...
Loading ...