Loading ...
Loading ...
Loading ...
Service Manual: SC750, SC800, SC 750 ST, SC800 ST
Form Number 56043150 Page 48
a. Use a small sharp knife to cut the tube o, near the sensor on the board (1 mm from sensor).
b. Make a shallow slit with the knife along the length of the clear tube that is sll aached to the sensor
port. Do not press too hard, and avoid cung into the sensor port. Make 3 or 4 passes with the knife,
pressing soly, rather than one hard cut. See the photos below.
c. To install the sensor onto a new PCB assembly, grasp the tube near the end with your ngers, and slowly
Loading ...
Loading ...
Loading ...