Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/Nilfisk-SC800-manual/bg78.png)
Service Manual: SC750, SC800, SC 750 ST, SC800 ST
Form Number 56043150 Page 120
Removal and Installation
Brush Head
1. Turn key on and push scrub on/o switch to lower the brush head to the oor. Then turn the key o and discon-
nect the main baery pack connector.
2. Disconnect the wiring for both brush motors. Note: the wiring connectors near one motor are not both for the
same motor. They are one posive for each motor or one negave for each motor, depending on which side you
are working.
3. Loosen the soluon hose clamp and remove the hose from the brush head. Remove the nut and bolt aaching
the ground wire to the brush head.
4. Remove the through bolt that aaches the brush head to the li mechanism bracket. Pay aenon to the
orientaon of the washers and bushings.
5. Carefully cut the e straps around the brush motor wire loops. (Do not damage the wires)
6. Raise the li bracket mechanism with your hand and slide the brush head assembly forward unl it clears the
machine.
7. Reassemble in reverse order.
Remove
Hose Clamp
and Hose
Remove
Ground Wire
Fastener
Loading ...
Loading ...
Loading ...