Loading ...
Loading ...
Loading ...
Frequently asked questions
96
With the help of the following guide, minor faults in the performance of the appliance,
some of which
may result from incorrect operation, can be corrected without contacting
the Service Department.
Please note that a call-out fee will be applied to unnecessary service visits where the prob‐
lem cou
ld have been rectified as described in these operating instructions.
Re
pair work to electrical appliances must only be carried out by a suitably qualified
person in strict accordance with current local and national safety regulations. Repairs
and other work by unqualified persons could be dangerous. The manufacturer cannot be
held liable for unauthorized work.
Technical problems
Problem Possible cause and solution
When the dishwasher is
turned on with the but‐
t
on, the display stays dark
and the Start/Stop indica‐
tor does not flash.
The dishwasher is not plugged in.
Inser
t the plug.
The circuit breaker has tripped.
Reset the cir
cuit breaker
(minimum fuse rating - see data plate).
The dishwasher stops dur‐
ing
a program.
The circuit breaker has tripped.
Reset the cir
cuit breaker (see data plate for the correct
fuse rating).
If the cir
cuit breaker trips again, contact Miele Customer
Service.
One of the following fault
messages is displayed:
Before fixing the fault:
T
urn the dishwasher off with the button.
Check water intake There is a problem with the water intake.
O
pen the faucet all the way.
Clea
n the filter in the water inlet (see "Cleaning and
care").
Fault 403-405 If Check water intake
appears in the display, the control unit
is checking the water intake approx. every 30 seconds. If,
after three attempts, water is not getting into the dishwash‐
er, one of these numbers will appear in the display and the
program will be cancelled.
Open the faucet all the way
.
T
urn the dishwasher back on.
Select the desir
ed program.
P
ress the Start/Stop button.
Loading ...
Loading ...
Loading ...