Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 361
7. Turn the low or high beam bulb a quarter
turn counterclockwise to remove from
housing.
8. Disconnect the electrical connector and
replace the bulb.
Front Turn Signal Lamp
1. Open the hood.
2. Access the back of the headlamp.
3. The air filter housing must be removed.
4. The windshield washer reservoir may need
to be rotated out of the way by removing the
fastener.
5. Coolant reservoir (if equipped) will need to
be repositioned by removing the fasteners,
and moving the unit out of the way.
6. Turn the turn signal bulb a quarter turn
counterclockwise to remove from housing.
7. Disconnect the electrical connector and
replace the bulb.
Front Fog Lamps
Please see an authorized dealer for service on
LED and Halogen front fog lamps.
Rear Tail, Stop, and Turn Signal Lamps
See below steps to replace:
1. Raise the liftgate.
2. Remove the two push-pins from the tail
lamp housing.
Tail Lamp Push Pins
3. Grab the tail lamp and pull firmly rearward
to disengage the lamp from the aperture
panel.
4. Twist socket counterclockwise and remove
from lamp.
Rear Of Tail Lamp
5. Pull the bulb to remove it from the socket.
6. Replace the bulb, reinstall the socket, and
reattach the lamp assembly.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
1 — Rear Turn/Stop Bulb Socket
2 — LED Tail Connector – Do Not Remove
3 — Backup Bulb Socket
8
21_WK_OM_EN_USC_t.book Page 361
Loading ...
Loading ...
Loading ...