Loading ...
Loading ...
Loading ...
FP (E1.1) 03/2019 page 20/90
If no button is touched during more than 120 sec. the controller returns from the actual level to Normal
Display.
6. Fixed value entry mode
If you do not want to use the week program timer, inactivate it (factory setting, setting in the
user level, chap. 10) before entering set-points. Any setting of the operation lines in fixed
value entry mode is ineffective with active week program timer.
Basic entry principle: Call up the individual parameters with button X/W one after the other. Enter the
values with the arrow keys. A value flashing once after 2 seconds indicates that it has been taken over to
the controller.
Normal Display
Display 1 shows
e.g. 19.8
(actual temperature value)
Display 2 shows e.g. 15.05.06 13:52 - -
(actual date and time)
(
actual switching state of week program timer channel 1: Off,
channel 2: Off
, visible only if week program timer is activated
in the user level, chap. 10)
Hit key
Display 1 shows
e.g. 20.0
(actual temperature set-point 1)
Display 2 shows
SP1 TEMPERATURE
(variable: temperature in °C)
Enter temperature set-point in °C with arrow
keys
Value is displayed in display 1.
Hit key
Display 1 shows e.g. 37.0
(actual temperature set-point 2)
(visible only if week program timer is activated
in the user level, chap. 10)
Display 2 shows
SP2 TEMPERATURE
(variable: temperature in °C)
Enter temperature set-point in °C with arrow
keys
Value is displayed in display 1.
Hit key
Display 1 shows
e.g. 100
(actual fan speed set-point)
Display 2 shows
SP FAN SPEED
(variable: fan speed in %)
Enter fan speed set-point in % with arrow
keys
Value is displayed in display 1.
Hit key
Only with option zero-voltage relay outputs via operation lines (chap 15.5):
Display 1 shows
e.g. 000
(actual switching state of operation lines)
Display 2 shows
OPERATION LINE
(variable: switching state of operation lines)
Enter switching state with arrow keys
Hit key
If no button is hit for more than 120 sec, or if the EXIT button is hit, the controller changes to Normal
Display.
When changing the set-point, check the setting of the safety device (chap. 14.1).
Loading ...
Loading ...
Loading ...