Loading ...
Loading ...
Loading ...
Q: If I change addresses, what do I do?
A: Reset the device and delete it from your account in the Wyze app.
You must repeat the setup process at your new address.
Q: Does it have a heat anticipator setting?
A: No.
Q: What if I have a K Terminal and what do I do with it?
A: The K terminal located on the Honeywell thermostat combines the
Y and G wires. It does this using the Honeywell wiresaver. The Wyze
system is not-compatible with the Honeywell wiresaver. However your
system is compatible with Wyze Thermostat once the Honeywell
wiresaver is removed.
Please follow the following step to install your Wyze Thermostat.
1. Take photos of your control board, thermostat wiring and
Honeywell wiresaver.
2. Remove the Honeywell wiresaver.
At the Control Board
1. On the "Thermostat" side of the Honeywell wiresaver, label the
wires as follows.
1.1. Rc terminal -> Rc Label
1.2. K terminal -> Y Label
1.3. C terminal -> G Label
1.4. W-O/B terminal -> Please follow the W-O/B terminal
wire from the wiresaver to the control board. Label the
wire on the thermostat side of the wiresaver
corresponding to the terminal label found on the control
board. Note: If the control board also is labelled
W-O/B, you will need to determine if your system is a
heat pump system(O/B) or conventional (W).
46
Loading ...
Loading ...
Loading ...