Loading ...
Loading ...
Loading ...
3. If turning on the heat doesn’t make your outside unit run, you’ll
probably hear sound coming from your basement, a closet, or
the ceiling when your heat is on. This would mean you have a
conventional system.
4. Check the labels on your condenser or indoor air handler for a
model number or name. You likely can search this up to figure
out what type of system you have.
Determining the kind of heating system you have
During setup, Wyze Thermostat will ask what type of system you have
and the type of fuel it uses. It’s important that you enter the correct
system information during thermostat setup.
Wyze Thermostat needs to know the type of heating system you have
so it can correctly control it. To help you choose the system you have,
here’s a breakdown of how each system works.
Forced Air
With this kind of heating system, warm air
comes out of vents throughout your home.
Image
In-Floor
Radiant
This utilizes electric coils or hot water pipes
under the floor of your home to provide heating.
Image
Radiators
Radiators are sealed metal containers filled with
hot water, steam or electric coils.
They’re similar to in-floor systems, since they
don’t use vents or fans, but radiators aren’t
installed under the floor.
Image
My Thermostat isn’t turning on after installing (No
Power)
You must have a wire in both the Rc and C terminal. Follow the below
guide, before attempting to adjust any wiring ensure the power is shut
off at the circuit breaker. Use either the breaker box switch or Power
switch at the furnace to turn off the power before attempting to adjust
the wiring.
Regardless of with or without CWA, the wiring on Wyze Thermostat
must match one of the two images below.
1. Before checking/adjusting any wiring, check that power to the
heating/cool system is powered on. If it is, turn it off again
before checking/adjusting any wires.
2. Check your wiring. Please note that Wyze Thermostat power
configurations only support the two images shown above.
1. Important: Rh cannot be used independently, the Rh
will have to be changed to Rc. Note the above image.
35
Loading ...
Loading ...
Loading ...