Loading ...
Loading ...
Loading ...
Heating and air conditioning system120
The heating effect is dependent upon the coolant temperature, thus full
heat output only occurs when the engine has reached its operating
temperature.
The blower should aways be on to prevent the windows from misting up.
WARNING
You should not leave recirculated air mode on over a longer period
of time. “Stale air” may result in fatigue in the driver and passen-
gers, reduce attention levels and also cause the windows to mist
up. The risk of having an accident increases. Switch recirculated
air mode off as soon as the windows begin misting up.
Note
• The whole heat output will be needed to unfrost the windscreen and
side windows. No warm air will be fed to the footwell. This can lead to
restriction of the heating comfort.
• The used air streams out through the air removal openings in the
luggage compartment.
Set heating
Recommended settings of heating controls for:
Defrosting the windscreen and side windows
• Turn control dial ⇒ page 119, fig. 116 to the right up to the stop
• Blower switch in position 3
• Turn the air distribution control into the position
• Open air outlet vents 3 ⇒ page 122, fig. 117 and point towards the side
window.
• Close the air outlet vents 4
Keeping windscreen and side windows demisted
We recommend that you use the following setting in cases where the
windows are misted up more than usual (e.g. when it is raining):
• Control dial where necessary to the heating range
• Blower switch in position 2 or 3
• Control dial to or as required or to any desired position
between these symbols
• Open air outlet vents 3 and point towards the side window
• Close the air outlet vents 4
Warming up the inside of the vehicle as rapidly as possible
• Turn control dial to the right up to the stop
• Blower switch in position 3
• Turn the air distribution control into the position
• Open the air outlet vents 3 and 4
• We recommend briefly pressing button air recirculation mode. The
windows can steam up in this position however.
Heating the vehicle to a comfortable temperature
We recommend the following setting once the windows are no longer
misted up and the desired teperature has been reached:
• Control dial at the desired heat output
• Blower switch in position 2 or 3
• Turn the air distribution control into the position
• Open the air outlet vents 3
• Close the air outlet vents 4
• Set the air distribution regulator as required between positions
and , if the windscreen gets misted up again.
A
A
A
B
A
C
A
A
A
B
A
C
A
A
A
B
A
C
A
1
A
A
A
B
A
C
A
C
s24s
.
book
Page
120
Thursday
,
November
24
,
2005
12:27
PM
Loading ...
Loading ...
Loading ...