Loading ...
Loading ...
Loading ...
Figure 3-1 Drill Holes on Turnsle
3. Solder the other four holes, polish the surface, and implement
wire drawing.
4. Solder circular tubes on the turnsle’s inner surface to avoid
water from entering.
Figure 3-2 Solder Tubes
3.2.2 Mount Bracket I
Steps
1. Install the base on the turnsle.
1) Align the hole on the turnsle and place the base on the
turnsle.
2) Rotate the base to the acquired place and make sure the
device will face a correct direcon.
3) Secure the base with 2 screws.
Figure 3-3 Install Base
4
Loading ...
Loading ...
Loading ...