Loading ...
Loading ...
Loading ...
●
Avoid backlight, direct sunlight, and indirect sunlight.
●
For beer face recognion, there should be light source in or
near the installaon environment.
●
Sunlight, wind, hot/cool air from air condioner and other
external factors, which may aect temperature, will create the
deviaon of the temperature measurement. In order to get an
accurate result, make sure the device is applied indoors and
windlessly (where is relavely isolated from the outdoors). The
working temperature should keep between 10 °C and 35 °C. If
there are no suitable environments for temperature
measurement (the area faces the indoor and connects the
outdoor, the area at the door of the indoor environment, etc.),
building a temporary temperature measurement environment
is suggested.
●
Inuence Factors of Temperature Measurement:
Wind: The wind will take the heat away, which may aect the
measurement result.
Sweat: The sweat will take the heat away, which may aect the
measurement result.
Air Condioner (Cool Air): If the indoor temperature is low, the
temperature may also lower than the actual temperature,
which may aect the measurement result.
Air Condioner (Heat) or Heang: If the indoor temperature is
high, the temperature may also be higher than the actual
temperature, which may aect the measurement result.
●
In order to make the device work properly, you should wait for
90 min aer the device is powered on.
●
For details about installaon environment, see Tips for
Installaon Environment.
3.2 Mount With Bracket
3.2.1 Preparaon before Mounng with Bracket
Make sure you have drilled holes on the turnsle. If not, follow
the steps below to drill holes.
Steps
1. Use 4 screws (M3 or M4), secured by ange nuts, to install the
reinforcing board on the inner surface of the turnsle.
Note
The distance between the turnsle and the edge should be no
longer than 10 mm.
2. Drill holes on the turnsle's inner surface according to the
gure displayed below. And install water-proof nut.
Note
Solder aer pressing rivets to avoid water from entering.
3
Loading ...
Loading ...
Loading ...