Loading ...
Loading ...
Loading ...
7102
User's Guide
9-10
9.8.2.1 Baud Rate
The baud rate is the first parameter in the menu. The baud rate setting
determines the serial communications transmission rate.
The baud rate parameter is indicated by,
bAUd Flashes “bAUd” and then displays the setting
2400 b Current baud rate
The baud rate of the serial communications may be programmed to 300, 600,
1200,2400, 4800, or 9600 baud. Use “UP” or “DOWN” to change the baud rate
value.
4800 b New baud rate
Press “SET” to set the baud rate to the new value or “EXIT” to abort the
operation and skip to the next parameter in the menu.
9.8.2.2 Sample Period
The sample period is the next parameter in the serial interface parameter menu.
The sample period is the time period in seconds between temperature
measurements transmitted from the serial interface. If the sample rate is set to 5,
the instrument transmits the current measurement over the serial interface
approximately every five seconds. The automatic sampling is disabled with a
sample period of 0. The sample period is indicated by,
SPer Flashes “SPEr” and then displays the setting
SP= 1 Current sample period (seconds)
Adjust the value with “UP” or “DOWN” and then use “SET” to store the sample
rate to the displayed value. “EXIT” does not store the new value.
SP= 60 New sample period
9.8.2.3 Duplex Mode
The next parameter is the duplex mode. The duplex mode may be set to full
duplex or half duplex. With full duplex any commands received by the calibrator
via the serial interface will be immediately echoed or transmitted back to the
device of origin. With half duplex the commands will be executed but not echoed.
The duplex mode parameter is indicated by,
dUPL Flashes “dUPL” and then displays the setting
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...