Dji CART 30 User Manual

Loading ...

DJI FlyCart 30

User Manual

Takeo/Landing

Takeo

The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the

bottom inner or outer corners to start the motors. Once the motors start spinning, release both

sticks simultaneously and take o as soon as possible. DO NOT start the motors if not planning

to take o right away, otherwise the aircraft may lose, drift or even take o automatically and

cause harm or damage.

• There is a six-second countdown and ESC beeping before the motor starts after

performing the CSC.

Landing

There are two ways to stop the motors:

1. When the aircraft has landed, push and hold the throttle stick down until the motors stop.

(Recommended).

Throttle Stick (left control stick in Mode 2)

2. When the aircraft has landed, perform the same CSC used to start the motors until the

motors stop. Release both sticks once the motors have stopped.

Method 2Method 1

• Spinning propellers are dangerous. Stay away from spinning propellers and motors to

avoid injury during takeo or landing.

• Make sure to keep hold of the remote controller and remain in control of the aircraft

until the motors stop.

• DO NOT stop the motors mid-flight, or it will cause the aircraft to crash. The motors

should only be stopped mid-flight if an emergency situation occurs, such as if the

aircraft is involved in a collision.

Loading ...

Dji CART 30