Loading ...
Loading ...
Loading ...
process, the instrument performs a series of self-tests. After the self-test, the splash
screen is displayed.
• Restart: Click or tap
> Restart. Then a prompt message "Are you sure to
reboot?" is displayed. Click or tap
OK to restart the instrument.
• Shutdown:
- Click or tap
> Shutdown. Then a prompt message "Are you sure to
shutdown?" is displayed. Click or tap
OK to shut down the instrument.
- Press
and a prompt message "Are you sure to shutdown?" is displayed.
Click or tap
OK to shut down the instrument.
- Press
twice to shut down the instrument.
- Press
for three seconds to shut down the instrument.
TIP
You can also click or tap
> Utility > Setup and set the "Power status" to "Switch on". The
instrument powers on once connected to power.
4.3.4 To Set the System Language
This oscilloscope supports multiple languages. You can click or tap > Utility >
Setup > Language to select the system language.
4.3.5 To Connect the Probe
RIGOL provides passive probes for DHO800 series. For specific probe models, refer to
DHO800 Data Sheet.
For detailed technical information of the probes, please refer to
the corresponding Probe User Guide.
Connect the Passive Probe
1. Connect the BNC terminal of the probe to an analog channel input terminal of the
oscilloscope on the front panel as shown in the figure below.
2. Connect the ground alligator clip or spring of the probe to the circuit ground
terminal, and then connect the probe tip to the circuit point to be tested.
Quick Start
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved. DHO800 User Guide
13
Loading ...
Loading ...
Loading ...