Loading ...
Loading ...
Loading ...
Installing the Mountain Bike Mount
NOTE: If you do not have this mount, you can skip this task.
1 Select a secure location to mount the Edge device where it does not interfere with the safe operation of your
bike.
2 Use the 3 mm hex key to remove the screw from the handlebar connector .
3 Select an option:
• If the handlebar diameter is 25.4mm or 26 mm, place the thicker pad around the handlebar.
• If the handlebar diameter is 31.8mm, place the thinner pad around the handlebar.
• If the handlebar diameter is 35 mm, do not use a rubber pad.
4 Place the handlebar connector around the handlebar, so that the mount arm is above the bike stem.
5 Use the 3 mm hex key to loosen the screw on the mount arm, position the mount arm, and tighten the
screw.
NOTE: Garmin recommends tightening the screw so the mount arm is secure, with a maximum torque
specification of 20lbf-in. (2.26N-m). You should check the tightness of the screw periodically.
6 If necessary, use the 2 mm hex key to remove the two screws on the back side of the mount , remove and
rotate the connector, and replace the screws to change the orientation of the mount.
7 Replace and tighten the screw on the handlebar connector.
NOTE: Garmin recommends tightening the screw so the mount is secure, with a maximum torque
specification of 7lbf-in. (0.8N-m). You should check the tightness of the screw periodically.
64 Device Information
Loading ...
Loading ...
Loading ...