Loading ...
Loading ...
Loading ...
Enable the Channel
The oscilloscope provides 2 analog input channels and provides a vertical control
system for each channel. As the vertical system setting methods are the same, this
chapter takes CH1 as an example to introduce the setting method of the vertical
system.
Connect a signal to the CH1 channel input connector; and then press the CH1
button in the vertical control area (Vertical) on the front panel to enable CH1.
The channel setting menu is displayed at the bottom of the screen and the channel
label at the right side of the screen. The information displayed in the channel label
is related to the current channel setting.
After the channel is turned on, modify the parameters such as the vertical scale, the
horizontal time base and the trigger mode according to the input signal to make
the waveform display easy to observe and measure.
Note: If multiple channels are turned on at the same time, you should view the
channel menu before turning off the channel. For example: If Channel 1 and
Channel 2 are turned on and the oscilloscope displays the Channel 2 menu,
press CH1 to display the Channel 1 menu, then press CH1 again to turn off
Channel 1.
Loading ...
Loading ...
Loading ...