Loading ...
Loading ...
Loading ...
Update Firmware and Configuration
The firmware and configuration can be updated directly via USB flash drive.
Do the following steps to update the firmware:
1. Insert the USB flash drive which contains the correct firmware and the
configure files into the USB host interface on the front panel of the
oscilloscope.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the Next Page softkey to go to the second page of the UTILITY function
menu.
4. Press the Next Page softkey to go to the third page of the UTILITY function
menu.
5. Press the Update softkey to enter the UPDATE function menu.
6. Press the Firmware softkey to open the file manager.
7. Turn the Universal Knob to select the update file which should be with an ADS
postfix; and then press the Press to Update softkey to start update the
firmware. The process needs about 7 minutes. And during the update, do not
remove power to the oscilloscope, otherwise the oscilloscope may be
permanently damaged and may not restart again.
8. After finish the update, the screen will pop-out the message “Firmware
decompressed. Please restart and wait…”.
9. Restart the oscilloscope to finish the firmware update.
Do the following steps to update the configuration:
1. Insert the USB flash drive which contains the correct firmware and the
configure files into the USB host interface on the front panel of the
oscilloscope.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the Next Page softkey to go to the second page of the UTILITY function
menu.
4. Press the Next Page softkey to go to the third page of the UTILITY function
menu.
5. Press the Update softkey to enter the UPDATE function menu.
6. Press the Configure softkey to open the file manager.
7. Turn the Universal Knob to select the update file ( *.CFG file extension) and then
press the Press to Update softkey to start update the firmware. The process
needs about 30 seconds.
8. After finish the update, the screen will pop-out the message “Firmware
decompressed. Please restart and wait…”.
9. Restart the oscilloscope to finish the configuration update.
Loading ...
Loading ...
Loading ...