OWON MSO8102T Logic Analyzer with 100 MHz 2 Ch Digital Oscilloscope

Manual - Page 21

For MSO8102T.

PDF File Manual, 112 pages, Read Online | Download pdf file

MSO8102T photo
Loading ...
Loading ...
Loading ...
16
Introduction to the Horizontal System
Shown as Fig.4-10, there are a button and two knobs in the "HORIZONTAL
CONTROLS". The following practices will gradually direct you to be familiar with
the setting of horizontal time base.
Fig. 4-10 Horizontal Control Zone
1. Use the horizontal "SEC/DIV" knob to change the horizontal time base setting
and observe the consequent status information change. Rotate the horizontal
"SEC/DIV" knob to change the horizontal time base, and it can be found that the
"Horizontal Time Base" display in the status bar changes accordingly. The
horizontal scanning speed steps from
2 ns up to 100s in the sequence of 1-2-5 ----- MSO7062TD,7102TD,8102T;
1 ns up to 100s in the sequence of 1-2-5 ----- MSO8202T.
2. Use the "HORIZONTAL POSITION" knob to adjust the horizontal position of
the signal in the waveform window. The "HORIZONTAL POSITION" knob is
used to control the triggering displacement of the signal or for other special
applications. If it is applied to triggering the displacement, it can be observed that
the wave form moves horizontally with the knob when you rotate the
"Horizontal Position" knob.
3. With the "HORIZONTAL MENU" button pushed down, you can set and initiate
the Window Expansion.
Introduction to the Trigger System
Shown as Fig.4-11, there are a knob and four buttons in the "TRIGGER
CONTROLS". The following practices will direct you to be familiar with the setting
of the trigger system gradually.
Loading ...
Loading ...
Loading ...