Loading ...
Loading ...
Loading ...
9
• Scan the QR Code below to view Operating The Cam Lock Service Video.
CAUTION
Using a hammer to drive the hex wrench into the panel fastener can result in damaging the interface
surface, rendering the lock unusable. Clear the hole of any debris if the wrench cannot be fully inserted
with normal hand pressure.
Section 2
Installation
General Installation Guidelines
• All insulated panels have a tongue and a groove perimeter edge. This interlocking design and the panel edge gaskets will
result in an air-tight walk-in when installed square and level. Refer to the assembly drawing for the general layout and
specific panel placement and markings.
• The tongue side of the panel and cam lock holes is on the left of each seam when viewed from the interior of the walk-in
(standing on the inside and looking out). The exact location of the tongue (M) and groove (F) for ceiling and floor panels, if
required, will be shown on the assembly drawing.
Loading ...
Loading ...
Loading ...