Loading ...
Loading ...
Loading ...
If the side window opens again slightly:
X
Immediately pull the corresponding switch on
the door control panel until the side window is
completely closed (Y page 77).
X
Hold the switch for an additional second.
X
If the respective side window remains closed
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above.
Problems with the side windows
G
WARNING
If you close a side window again immediately after it has been blocked or reset, the side window
closes with increased or maximum force. The reversing feature is then not active. Parts of the
body could be trapped in the closing area in the process. This poses an increased risk of injury or
even fatal injury.
Make sure that no parts of the body are in the closing area. To stop the closing process, release
the switch or push the switch again to reopen the side window.
Problem
Possible causes/consequences and MM Solutions
A side window cannot be
closed because it is
blocked by objects, e.g.
leaves in the window
guide.
X
Remove the objects.
X
Close the side window.
A side window cannot be
closed and you cannot
see the cause.
If a side window is obstructed during closing and reopens again
slightly:
X
Immediately after the window blocks, pull the corresponding switch
again until the side window has closed.
The side window is closed with increased force.
If a side window is obstructed again during closing and reopens again
slightly:
X
Immediately after the window blocks, pull the corresponding switch
again until the side window has closed.
The side window is closed without the automatic reversing feature.
The side windows cannot
be opened or closed with
convenience opening.
The SmartKey battery is discharged or nearly discharged.
X
Check the SmartKey battery (Y page 69) and replace it if necessary
(Y page 69).
If a side window will still not open or close due to a malfunction, consult a qualified specialist
workshop.
Side windows
79
Opening and closing
Z
Loading ...
Loading ...
Loading ...