Loading ...
Loading ...
Loading ...
Problem
Possible causes/consequences and MM Solutions
The engine is not running
smoothly and is misfir-
ing.
There is a malfunction in the engine electronics or in a mechanical
component of the engine management system.
X
Only depress the accelerator pedal slightly.
Otherwise, non-combusted fuel may get into the catalytic converter
and damage it.
X
Have the cause rectified immediately at a qualified specialist work-
shop.
The coolant temperature
display shows a value
above 248 ‡ (120 †).
The coolant level is too low. The coolant is too hot and the engine is no
longer being cooled sufficiently.
X
Stop as soon as possible and allow the engine and the coolant to
cool down.
X
Check the coolant level (Y page 239). Observe the warning notes
as you do so and add coolant if necessary.
DYNAMIC SELECT controller
General information
Select the drive program using the DYNAMIC
SELECT controller.
Available drive programs:
C Comfort Comfort-oriented, optimum-
economy engine and trans-
mission settings
S Sport Sporty engine and transmis-
sion settings
S+ Sport Plus Especially sporty engine and
transmission settings
RACE
(AMG GT C
Roadster)
Maximum sportiness and
engine and transmission
settings suitable for the
racetrack
I Individual Individual settings
In urban traffic and stop-start traffic, drive pro-
gram C is recommended.
Depending on the drive program selected the
following vehicle characteristics will change:
R
the drive (engine management)
R
the transmission management
R
ESP
®
(Y page 62)
R
the suspension (Y page 147)
R
the position of the exhaust flap
(Y page 114)
R
the availability of the ECO start/stop function
(Y page 113)
R
the availability of gliding mode
(Y page 120)
Further information for automatic drive program
characteristics (Y page 122).
Additionally, in drive program I you can config-
ure the respective vehicle characteristics using
the multimedia system. You can find informa-
tion about this in the Digital Operator's Manual.
Each time you start the engine with the Smart-
Key or the Start/Stop button, drive program C is
activated. For further information about starting
the engine, see (Y page 111).
Selecting the drive program
X
Turn DYNAMIC SELECT controller : until the
desired drive program is selected.
The selected drive program appears in the
multifunction display. After five seconds the
116
DYNAMIC SELECT controller
Driving and parking
Loading ...
Loading ...
Loading ...