Loading ...
Loading ...
Loading ...
25
EVE616, EVE626, EVE636
BEFORE USING THE APPLIANCE
Preparing the appliance
1. Please remove all stickers and protective film from
doors, and remove all leaflets and boxes from the
floor of the oven before operation.
2. Please wipe out the oven interior prior to operation
with warm soapy water and polish dry with a soft
clean cloth. Do not close the oven door until the oven
is completely dry.
3. Do not line the oven with foil. It will damage
the enamel.
Setting the time
The time of day must be set before the appliance
can operate.
After the appliance has been electrically connected the
display will cycle through the welcome screen, then ‘Set
Clock’ will illuminate under the clock display and the Hour
digits will flash.
1. Use the timer + and – to set the hour portion of the
current time (including AM/PM).
2. Press OK when the hours are set correctly. The
Minute digits will flash.
3. Use the timer + and – to set the minutes portion of
the current time.
4. Press OK when the minutes are set correctly. You
can turn the the oven off or it will do so after 8
seconds. Once the time has been entered, the clock
advances minute by minute.
NOTE: The clock has a 12 hour display and will remember
the time for 3 days without power.
IMPORTANT
New appliances can have a smell during first use.
It is recommended to ‘run in’ the oven before
cooking for the first time. Operate the oven, empty,
at a temperature of 180°C for approximately
30 minutes.
Please ensure the room is well ventilated during
this process.
Installing your oven accessories
Side racks
Insert the twin pegged end into the rear access holes
provided, ensuring pegs are fully inserted.
Then locate the front peg into the front access hole and
push in firmly.
NOTE: If you have purchased an EVE626 you will have
additional side racks for the lower oven/grill. These are
fitted in a similar manner, however the left hand side rack
must be fitted to the lower two holes of the half cavity.
Shelves and trays
The shelves are designed so that they have maximum
extension but cannot be accidentally pulled right out.
The trays are designed the same way and slot straight
into the side racks.
To fit a shelf or tray to side racks:
1. Locate the rear edge of the shelf/tray in between the
guide rails of the side rack – see diagram. Ensure
the same rail positions on both sides of the oven are
being engaged.
2. With the front edge raised, begin to slide the shelf into
the oven.
3. Once the detents have passed the front edge of the
side rack, the shelf can be pushed completely in.
Loading ...
Loading ...
Loading ...