Loading ...
Loading ...
Loading ...
Where will I find...?
Reflective safety jacket
Removing/replacing the reflective
safety jacket
The reflective safety jackets are located in the
safety jacket compartments in the stowage
compartments of the front doors. There are also
safety jacket compartments in the stowage
compartments of the rear doors, in which reflec-
tive safety jackets can be stowed.
X
To remove: pull out safety jacket bag : with
the reflective safety jacket by loop ;.
X
Open safety jacket bag : and pull out the
reflective safety jacket.
X
To stow: fold the reflective safety jacket, roll
it up and stow it in safety jacket bag :.
X
Slide safety jacket bag : along the lower
edge of the armrest into the safety jacket
compartment. Meanwhile, ensure that
loop ; hangs out well within reach.
X
Observe the legal requirements in each indi-
vidual country for the use of safety jackets.
i
Remove a new reflective safety jacket from
its packaging material before sliding it into
the safety jacket compartment. The packag-
ing material may otherwise cause it to slip out
or make removing it difficult.
Information on reflective safety jackets
:
Maximum number of washes
;
Maximum wash temperature
=
Do not bleach
?
Do not iron
A
Do not use a laundry dryer
B
Do not dry-clean
C
This is a class 2 jacket
R
The safety jackets only meet the require-
ments defined by the legal standard:
-
if the correct size is used
-
if the reflective safety jackets are correctly
fastened
R
Before use, ensure that the reflective safety
jackets are clean and intact. The special prop-
erties may otherwise be compromised.
R
The reflective safety jackets should be stored
in their original packaging in a dry place away
from sources of heat and light.
R
The maximum number of washes specified is
not the only factor influencing the life span of
the reflective safety jackets. Their life span
also depends on use, care, storage, etc.
R
The reflective safety jackets should be dis-
posed of and replaced with new ones:
-
after 15 washes, and/or
-
if the reflective strips have become
scratched, and/or
-
if the backing material and/or reflective
strips have become soiled and cannot be
cleaned off, and/or
-
if the fluorescence has faded, for example
due to the effects of sunlight
R
Dispose of reflective safety jackets in an envi-
ronmentally responsible manner. To do so,
contact your local waste disposal company.
Where will I find...?
313
Breakdown assistance
Loading ...
Loading ...
Loading ...